Wanhao i3 Filament Guide for enclosures
Description
Loved The Original, But When I Got Ride Of The Spool Holder I Needed Something Stronger And I Needed It To Be Positioned Better To Fit Where My Printer Is Installed In My Enclosure. There Is Two Sets Of Usable Holes I Believe, Though I'M Not 100% Sure You Can Use The Front 2. The Front Hole May Be Vestigial Unless You Install It With Just 1 Screw. I Ran A Couple Prints With An Earlier Shorter Prototype That Way And It Worked Fine. I Rotated The Opening From The Original Since I Didn'T Like It Right In Front, So I Got It Angled As Far Right As I Could So It And The Holder Could Give As Much Room In The Back And Sides As Possible For Filament To Slide Without Ending Up In The Slots. Works With The Locker Created For The Original: Https://Www.Thingiverse.Com/Thing:1280498
Statistics
Likes
3
Downloads
0