Simple Pegboard Filament Spool Holder
Description
This Is An Original Design Done In Openscad, But Enough Inspired By A Couple Pre-Existing Things That I'M More Comfortable Calling It A Remix There-Of. This Is A Very Simple 2-Piece Spool Holder For Pegboard. Stick Both Cylinders Into Opposite Sides Of Your Spool Such That The Smaller Cylinder Nests Inside The Larger One, Then Hang The Whole Thing On Your Pegboard. It Does Make Use Of My [Pegboard Base Library](Https://Www.Thingiverse.Com/Thing:2583402) Since I Didn'T Feel Like Modeling Up The Pegs Again Even Though I Didn'T Use Most Of The Base Functions. I'M Lazy Like That. The Two Halves Are Very Simple And Should Print Easily On Almost Anything.
Statistics
Likes
4
Downloads
0