Anet A8 Y Motor Mount for NEMA Dampener
Description
Since I Currently Only Print In Pla And The Tension Of The Belt Induces Torque On The Motor Mount, The Original File Was Warping. The Uneven Torque Is Not Good For The Motor Shaft, As It Can Damage It, And You'Ll Need To Replace The Entire Motor. I Strengthened The Part To Resist The Torque. Further Upgrading Can Be Done, But Unless I Come Into Further Complications, This Should Suffice. If You Have An Upgraded Z Endstop Print And Purchased These Nema 17 Motor Dampeners, You'Ll Need To Print This Part Too: Https://Www.Thingiverse.Com/Thing:2568315 Nema 17 Stepper Motor Dampener: Https://Tinyurl.Com/Yalhohrr
Statistics
Likes
39
Downloads
0