Frame Motor for Kossel / Deltaprinter 20x20
Description
This Is Sort Of A Remix From The Kossel "Frame_Motor_2020Sw". Which Means I Created The Thing Completely New In Fusion360. I Could Not Found The Source Because There Are So Many Of These Parts On Thingiverse. Changes I Made: - Changed The Distance For The Motor, To Ad A Vibration Damper Which I Found Here Https://De.Aliexpress.Com/Item/Hot-Sale-5-Pcs-Lot-Nema-17-Stepper-Motor-Vibration-Damper-Shock-Absorber-For-42-Step/32764435765.Html - Made The Cutout For T-Nuts Bigger - Made Holes Through The Whole Part For Tighten The Screws For The Motor - Made A Small Cutout On The Underside For Cables (Endstops) - Smaller Radius Next To The Screws, Which Holds The Motor For Adding Washers - Just 3 Instead Of 4 From This Long Sections Parallel To The Extrusion Version 1: Tested. A Little Bit Hard To Insert The Extrusion, And Not To Much Space For Cables On The Underside. Version 2: Tested. Bigger Cutout On The Underside (Radius 5Mm Instead Of 2.5Mm), Smaller Radius In The Corners, Where The Extrusion Goes Through (0.5Mm Instead Of 1Mm) Version 3: Tested. Small Update. Rounded The Corner/Area Where The Cable Bends From The Underside To The Extrusion. Had Some Troubles To Move The Cable, When The Extrusion Was In Place. And Changed The Logo Slightly :-) Any Feedback Is Welcome
Statistics
Likes
12
Downloads
0