Pumpkin Bucket
Description
A Halloween Without Candy Is A Trick! Do Not Go Outside Without This Cube With Flashing Lights. This Is An Easy Impression But It Is Large. It Measures Approximately 120 Mm Round And 80 Mm High. No Supports Required. Printed At 0.2. The Pieces Fit Perfectly, It Is Not Necessary To Use Glue. For The Handle You Can Use A Wool Yarn. Insert The Thread Through The Holes And Tie A Knot. You Can Use The Pumpkin Bucket Without Lights. Although, If You Want To Add The Lights, See The Following Information. Blinking Lights ============ You Need: - 1X Arduino Nano - 5X Yellow Leds - 5X 220 Ohm Resistors - 1X 9V Battery - 1X 9V Battery Adapter - Wires Schematics ---------------  Assembly ------------- Step 1: Solder The Leds With The Resistors Step 2: Solder The Cables Following The Schema. Step 3: Glue The Leds In The Correct Position With Hot Glue. Two Leds In The Eyes And Three In The Mouth. Step 4: Connect The Led Cables To An Arduino Nano On Pins 5 And 6. Step 5: Connect The Battery And Insert The Circuit Into The Pumpkin. Step 6: Place The Bucket Inside The Pumpkin. Arduino Code And Schematics Here: Https://Github.Com/Slaanevil/Randomblinkled Demo Video Https://Youtu.Be/Vbbhfmdsmfu Assembly Video Https://Youtu.Be/X4Ompzuu-Ko
Statistics
Likes
18
Downloads
0