Turnout for OS-Railway - fully 3D-printable railway system!
Description
This Is The Same Turnout That Has Been Included In The Main Track Page. I Decided To Move It To A Separate Page To Keep Things More Clear. Main Track Page: Https://Www.Thingiverse.Com/Thing:2146361 See Video Below For Building Instruction. Quick Tips: Material: Pla Layer Height: 0,2Mm Support: Only For Swinging Track Parts (Printed Upside Down) Hardware Needed: None. (No Screws Or Any Extra Except Tools). Print The Swign Track Assembly Stl'S, Only Use The Ones That Ends With 1 Or 2 If You Need To Print An Extra Of Any Of Them Alone. <B>Note!</B> This Is Not Said In The Video, If The Train Keeps Derailing When Running On The Turning Part Of This Turnout, It Can Be Due To The Gap Where The 2 Different Rails Intersects Being Too Narrow. You Can Increase The Bap By Cutting Away A Bit Of The Straight Track, A Millimeter At A Time Until The Train Can Pass Without Derailing.
Statistics
Likes
196
Downloads
0