Carbon Fiber Drone Gimbal for CNC Cutting
Description
This Is A Fairly Straightforward Gimbal For Cnc Cutting Out Of Carbon Fiber Or A Similar Material. It'S Based Around T-Motor (Rctigermotor.Com) 4106 Motors, Which I Use With A Simplebgc 32Bit Rev2 Controller And Navio2 Controller. It Is Intended To Be Cut Out Of A Combination Of 1Mm And 2Mm Carbon Fiber, And There Is A Layer And Cut File For Each. I Used A 0.6Mm Bit, With The Cf Clamped To 1/4" Hardwood Around 1/4" Foamcore To Allow Me To Run The Bit Out At Full Depth (To Reduce Stress At The Shank Interface Where They Usually Break If You'Re Cutting With The Tip Of The Bit). If You Would Like One Cut For You, Just Contact Me And I Can Come Up With A Reasonable Price Depending On What Your Needs Are.
Statistics
Likes
3
Downloads
0