M5 Nut and Bolt
Description
I Wanted To Push My Printer Far And I Was Quite Skeptic About This, But For My Surprise It Did Print These Parts Good After A Few Tweaks To The 3D Model And Cura Settings. Turn These Parts In Your Slicer Program 90 Degrees!! Some Times The Screw Would Get Loose From My Bed So I Played With My Settings And With These It Worked For Both The Screw And Nut. Hope It Works With Your Setup Too. I Did Not Use Any Glue. I Was Amazed About The Quality And That It Was Even Possible To Print M5 Threads On The Cr-10. I Have Not Tried To Fit These Parts With Actual M5 Nut And Bolts Since I Had To Make Minor Adjustments On The Threads In 3D Modelling Software To Be Able To Fit These Together. Hope You Guys Will Have The Same Result Or Better Than I Did, Happy Printing!
Statistics
Likes
120
Downloads
0