Replicator 2/2x Pivoted Blower Duct
Description
I Decided To Modify Original Blower Duct Of Whpthomas In Order To Gain Access To The Screws Under The Extruder Carriage. This Version Has A Pivot Between The Support And The Duct, So You Will Get Off The Carriage Without Unscrewing The Duct, But Simply Moving It. As Pin I Used A 3X20 Screw Because Only The Last Piece Of Duct Is Threaded, The Remaining Is A Bit Larger To Avoid The Pin Unscrews By Rotation. Printed Using Pla At 210°C, Layer 0.2, Raft And Supports (Simplify3D) Infill 20% 2 Shells
Statistics
Likes
10
Downloads
0