Seed Starting Pot and Base
Description
I Made This To Hold My Seed Starting Peat Pots. It'S Made To Let Excess Water Drain Out And The Base Is A Kind Of Auto Watering System. Hopefully. I'M Still Printing Them Out, The Cups Take About 4 Hours And 20 Minutes A Piece, About 8 And A Half Hours If You Print Two At One Time. The Base Takes About 3 Hours, One At A Time. I Have It Set To 15% Infill, 2 Shells, And .20 Mm Layer Height, Using Makerware And Makerbot Replicator 2. It Printed Fine, A Few Pulled Up, And One Of The Bases Did. I Would Recommend A Heated Build Plate, But It Will Work Fine Without It. I Made This In Vectorworks 2008, Which Isn'T The Easiest Program To Do Designs In. If Anyone Has Any Suggestions For Alternate Programs, I Will Gladly Try Them Out.
Statistics
Likes
51
Downloads
0