Ultimate Allen/Hex Key Screwdriver
Description
Hey Guys, This Project Came About Because My Good Set Of Hex Bits Snapped. I Did Not Have Any Money To Buy A New Set So I Decided To Make One For Cheap Instead. A Good Hex Driver Set Can Go From $30 And Above But With This, You Could Easily Cut The Price Down To $1 For Each Driver. I Have Not Tested Every Single File So If There Is Anything Wrong With Any Of Them, Please Message Me! I Will Be Adding Various More Handles, So If You Have Any Suggestions Of A Specific Type Of Handle You'D Like, Message Me! Thank You! <B>This Design Will Fit:<B> * Metric: 1.5, 2.0, 2.5, 3.0, 4.0, 5.0, 5.5, 6.0. * Sae / Inch / American: 1/8, 1/16, 3/16, 3/32, 5/32, 5/64, 7/32, 7/64, 9/64. <B>Note:<B> * I Have Used Left Handed Screw Threads For This Project. * The Handle Has A Pilot Hole So You Could Use Any Screw To Hold The "Holder" Parts Against The Handle. I Used An M3X10 Button Screw For Mine. * If You Choose To Have A Thumb Screw On The Handle, You Could Have Interchangeable Keys! * Depending On Your Printer, You May Need A Nozzle Smaller Than 0.4Mm To Print The 6Mm Key And The 9/64 Key. <B>Printing Tips:<B> * You Would Need To Flip The "Holder" Files 180 Degrees, And Add Supports That Are Only Touching The Build Plate. * You Will Need To Flip The "Ring" Files 180 Degrees. These Files Do Not Need Any Supports. * The Handles Should Be Printed Up Right With No Supports As Well. * The Tolerance Of My Parts Is + 0.3Mm From True Measurements. This Yielded A Perfect Fit For My Printer (Anet A8). <B>Interpreting The Files:<B> * The Screwdriver Is Composed Of Four Pieces: "Holder" (2 Halves), "Ring", And Handle. * Each File Has The Size Of The Key You Would Want To Use For It. * The "Holder" Is Composed Of Two Pieces And Is Labeled "L" Or "R" To Differentiate Them. Example: If You Have A 1.5Mm Hex Key You Would Need To Print "Holder_1.5Mml", "Holder_1.5Mmr", "Ring_1.5Mm" And Your Handle Of Choice. <B>Print Settings (What I Used And Recommend):<B> * I Used A 0.4 Mm Nozzle. * Printed In Petg Plastic (Any Plastic Could Be Used). * I Used 40% Infill For The Handle With 3 Layer Walls. * I Highly Suggest 100% Infill For The "Ring" Files And At Least 40% Infill On The "Holder" Files.
Statistics
Likes
873
Downloads
0