Cover for Park Tool CCP-22 or CCP-44 crank puller
Description
In The World Of Niche Products, This Is A Winner. Can'T Imagine Many Folks Will Have A Need For This One. I'Ve Got Two Of The Park Crank Pullers, And One Of Them Goes In The Toolbox That I Keep In The Car. Thing Is, I Like To Keep Tool Threads Clean And Well Lubed, But Sitting In A Toolbox This Might Not Stay Clean, So I Decided To Make A Cover To Keep It Clean When It'S Not Used. Remixed From A Nut Job M22X1 25Mm Long Nut - I Then Removed The Surfaces For The Wrench Flats And Extended The Circular End, And Created A Cap At One End. Actual Thread Size Is 22.5Mm As The 22Mm Was Way Too Tight And 23Mm Fell Off. Could Probably Have Been 22.3Mm For A Slightly Better Fit But It'S Not Bad Enough To Merit A Reprint.
Statistics
Likes
5
Downloads
0