CR-10 Control Stacker (Works also with Wanhao Dup i3,Malyan M150 and Monoprice Select)

Description

Hi, This Is Some Stacker Stand That I Have Design For My 2 Cr-10 I Wanted To Limit The Space They Were Taking And I Also Had 2 Creality Controller Extension Wires Kits That Way I Only Needed One …..This Design Could Allow You To Stack 3 Or Maybe 4 Controllers Set Most For Them To Be Stables, Also I Am Sure You Could Use Them For Other Similar Controllers On Other Printers Like The Wanhao, Malyan And Monoprice Anyway, Here Is The How To …. 1-Print 2 Of The Stand At The Infill You Want I Used 15% With The Filament Of Your Choosing. 2 -I Have Use Some Dollar Store Antiskid Rubber Mat With Contact Cement To Have A Good Solid And Stable Surface Under And Over The 2 Faces Of Each Stand, Over Cut It And Trim With A Sharp Utility Knife After You Have Glued Them ….. 3-I Did The Bigger Holes At 10Mm So I Could Insert Wooden Dowel So Both Stands Would Make One Solid Unit, I Have Used 3 200Mm Long Dowel And 2 50Mm Dowel Because You Cannot Put 4 Otherwise You Will Have Clearance Problem With The Usb Port And Sd Port … So I Have Used Gorilla Glue To Set Them Up In The Stand… I Have Bought The Dowel At The Dollar Store As Well In The Art Section… The Size Is 3/8 “ Or 9Mm I Finish The Dowels With Electrical Black Tape And Used A Sharpie To Blacken The Ends Of Them …. And Voila You Only Need To Set Up All Of This And You Can See The End Results In The Following Pics Enjoy

Statistics

Category

Tags