Remix of MPCNC Tangential Knife
Description
**Update 12/2/2017** Replaced Olfa Blade Holder With **Mpcnc_Tn_Olfabladeholder_Rev73.Scad** To Add Recessed M3 Nut Traps For Cover. Also Added A Version For Mini Utility Blades **Mpcnc_Tn_Miniutilitybladeholder_Rev14.Scad** **Update 11/30/2017** Added **Mpcnc_Tn_Olfabladeholder_Rev72.Scad** For Using Olfa Blades. There Is A Dimensioned Image Showing The Variables Used That You Can Change. I Did Not Make A Stl File Of This, Since I Am Not Sure Whether The Dimensions For The Blade I Have Are Different Than Others. **Update 11/22/2017 #2** Simplified The Design For Using 8Mm Rod Instead Of The M8X70Mm Bolt. Files To Use For This Are **Mpcnc_Tn_8Mmrodblade_Holder_Rev32.Stl** And **M8_Rod_Collar_Rev1.Stl** **Update 11/22/2017** I Made A Version 20Mm Shorter Which Is A Simpler Design & Should Work Better. Use **Mpcnc_Tn_Shortblade_Holder_Rev22.Stl**. This Would Use The M8X70Mm Length Bolt Still. This Remix Has Not Been Tested Yet, So Use At Your Own Risk. I Have Printed The Parts & Test Fit A Stanley Box Cutter Blade In The Test Print As Shown In 3 Of The Photos. This Is A Remix Of The Blade Holder, Bolt Clamp & Blade Clamp. I Modified This To Be Able To Make The Bolt Closer To The Blade & Hopefully Make It More Stabile. I Also Changed The Blade Clamp To Cover More Of The Sharp Blade. The Blade Clamp Also Has A Slight Ridge To Keep The Blade In Line. I Also Changed The Notch In The Blade Holder Where It Catches 1 Of The Notches On The Blade. That Was A Little Too Tight For Me. If You Want To Test The Fit Of The Blade, Print **Mpcnc_Tn_Blade_Holder_Test_Rev21.Stl**. This Should Be Less Than A 20 Minute Print. If You Are Using The M8X70Mm Hex Bolt Cap Screw, The Parts You Want To Print Are **Mpcnc_Tn_Blade_Holder_0Mmadd_Rev21.Stl**. If You Want To Use M8X80Mm Use **Mpcnc_Tn_Blade_Holder_10Mmadd_Rev21.Stl** Or M8X90Mm Use **Mpcnc_Tn_Blade_Holder_20Mmadd_Rev21.Stl**. I Designated Them This Way Because The Machine Mount I Am Going To Use Will Probably Be Longer Bolts. The Bolt Length Can Be Changed In The Openscad File By Adjusting The Variable **Len_Add** To A Value From 0 To 20. See The Original Design: Https://Www.Thingiverse.Com/Thing:2624654 For Further Details On This Design.
Statistics
Likes
48
Downloads
0