Pontoon Wing Connector for Sea Otter
Description
This Download Includes Both The Wing Connector And The Center Section. Print At 100% Scale, 0.2, 10% Infil. Back Edge Of Wing Connector Needs (I Used Good Wire Cutters) Trimming About 2-3Mm To Allow For Downward Movement Of Ailerons (I May Fix In Next Version If Time Allows). You Will Need To Download And Print This (Https://Www.Thingiverse.Com/Thing:2432679 (Thanks To @Pauljs75)) File For The Pontoon (Or Similar), And Resize It Appropriately (I Printed The Pontoon At 2700% Scale, 0.2, And 5% Infil). Hot Glue Worked To Get Everything Together, But Be Careful As Pla Will Melt Slightly, So Use Enough First Time And Try Not To Re-Position. One Additional Note, I Had To Sand The Tops Of The Center Sections So They Would Fit In The Grooves On The Connector Piece Slightly.
Statistics
Likes
4
Downloads
0