anti z-wobble, M8, 8 mm guide
Description
Yet Another Anti Z Wobble Part. I Use It On My Geeetech I3, But It Should Fit On Other Printers With An M8 Lead Screw And An 8 Mm ⌀ Guide Rod. (Maybe Not The Anet A8, That May Have A Proper Lead Screw) This One Is Reasonably Flat, So You Should Not Have To Move Up Your Printing Platform, As I Had With Some Of The Other Designs I Tried. With This, The Force Of The X Axis Assembly Completely Rests On The M8 Nut. The Smooth Rod Arms Are Used Only For The Torque On The Nut. They Act Only As A Wrench, Not Transferring Vertical Forces And Are Flat Enough To Fit Under The Sliding Bearings On The Rod. You’Ll Need A Pair Of Standard¹ M8 Hex Nuts. The Picture With The Red Parts Are A Before And After Comparison. It’S Philbarrenger’S [Monster Mouth Headphone Holder](Https://Www.Thingiverse.Com/Thing:1657541), Which I Reprinted To Get Rid Of The “Nail File” Ridges, Once I Had Found Out What The Problem Was.
Statistics
Likes
7
Downloads
0