Hobby Lobby Hunter/Tornado electronics & steering mounts
Description
Wip Printed Everything Up And It All Fits Pretty Darn Well. Won'T Know For Sure Until I Fit The Engine And Exhaust. The Front Bell Cranks May Also Get Adjusted If I Run Into Clearance Issues With A Center Driveshaft Pillow Block On A 4X4 Model. * Rearrangement Of The Radio Gear And Steering Setup For A Hobby Lobby Hunter. * Uses Stock Mounting Holes. (At Least The Holes That Were On My Test Chassis, Ymmv) * Radio Box Is Sized To Fit A Tower Hobbies 224 Receiver And A 6V Receiver Battery Hump Pack. The 5Aa Nimh Variety In A 2X3 Shape. In The Pic I'M Using A 6Aa Holder, But I'M Going To Short One Of The Battery Spaces. * Radio Box Lid Is Held In Place With A Rubber Band. * Still Need To Add A Little Bit Of Wire Management For The Steering Servo. Probably A Simple Tie Down Like Device. * The Servo Saver I'M Planning To Use Is The Type That Is Incorporated Into The Servo Arm Horn. Specifically A Kimbrough Large Servo Saver. Hardware List: Tbd - Various 3Mm Bolts And Nylocks Of Various Sizes 6 3Mmid X 3.5Mmod X 5Mm Long Brass Tubing To Act As Bushings For Steering Arms And Drag Link.
Statistics
Likes
12
Downloads
0