DIY Prusa i3 Cable Management Clamp
Description
This Diy Prusa I3 Cable Management Part Was Designed To Provide A Way To Clamp And Zip Tie To Keep All The Wiring Clean. The Ramps Board Was Installed Towards The Bottom Of The Frame. The Cable Management Part Is Meant To Screw Into The Original Top 3 Holes On The I3 Mk2S Frame (In My Case, Made Out Of Plywood). Note That There Are 3 Smaller Holes At The Top To Insert A Nylon Stiffener That Runs With The Bundles Of Wires. I Used Green/Yellow Weed Whacker Material As My Stiffener.
Statistics
Likes
1
Downloads
0