DIY Prusa i3 x-end-idler and -motor for anit-backlash T8 brass nut
Description
This Is A Modification To Prusa'S Original Mk2S X-End-Idler And X-End-Motor Carriage Mounts To Fit The T8 Anti-Backlash Brass Nut. I Tried To Keep The # Of File Changes To A Minimum, So Only The 2 Scad Files, X-End-Idler And X-End-Motor, Were Modified. This Requires You To Hacksaw 2 Of The 4 Mounting Holes On The Brass Nut, To Make Them Into Open Slots. The Opening On The X-End Carriage For The Brass Nut Is 12Mm Diameter To Accommodate The Anti-Backlash Spring+The Brass Nut. I Took Into Account The Center-To-Center Distance Of 17Mm Between Z-Rods & Z-Screw. This Worked Perfectly For Me With Zero Slop. Hope This Works Well For You Too!
Statistics
Likes
43
Downloads
0