Corner or bracket for printer enclosures made with PVC tubes
Description
This Corner Will Fit On 1/2" Schedule 40 Pvc Conduit From Home Depot Or Any Other Hardware Store. To Get A Full Enclosure, Print 8 Of Them. To Do The Enclosure Faces, I Decided To Go For 5 Panels Made Of "Reflectix Small Project Rolls" Panels (Or Multi Layer Reflective Insulation) From Home Depot (24In X 10Ft) Which Is Enough For A Cr10S Enclosure. To Hold The Insulation On The Frame, I Used Velcro In The Corners And Printed Clips In Between (See My Other Related Things To Find Those Clips). The Front Panel Is Fixed With Velcro Only So That I Can Remove It Easily. What Is Missing Is An Inside Light, And You Are Good To Go. The Holes In The 2 Diagonal Bracings Are There To Link Two Diagonally Opposed Corners With A Wire To Increase Structure Rigidity If Needed. The Through Holes Within The 3 Branches Are To Fix The Pvc Tube Within The Bracket If Needed (Use A Drill To Drill The Tube And Use A Wire Or Something To Go Through The Bracket And Pvc Tube). This Is Probably The Cheapest And Easiest-To-Make Enclosure. 3X Of Pvc Tube Cost 6$, One Roll Of Reflective Insulation 10$, 5Ft Of Velcro 7$ And Some Wire For 3$ Make A Total Of 26$ Without Filament.
Statistics
Likes
427
Downloads
0