Edge lit acrylic sign with printed base with 12 designs
Description
These Are Some Edge Lit Signs I Have Designed Along With A Neat Little 3D Printed Base To House The Electronics. The Base Is A Clam Shell Design And The Legs Snap On. You Will Need A 12V Power Supply With A 2.1Mm Barrel Jack Connector To Power This Bad Boy. I Use Cast Acrylic, Cut On A Cnc Router For The Sign Portion. You Can Etch, Engrave Or Sandblast Any Clear Plastic And It Should Work, But Cast Acrylic Is Very Easy To Work With. Https://Www.Amazon.Com/Gp/Product/B01Lzuuh3K/Ref=Oh_Aui_Detailpage_O06_S00?Ie=Utf8&Psc=1 Here Is The Led Strip I Used. Its Pretty Standard Weather Resistant 4 Pin Pwm Rgb Strip. You Can Use Whatever, But The Cutout Is Sized For The Weather Resistant Stuff. Https://Www.Ebay.Com/Itm/5-Pcs-Mini-3-Key-Controller-Dimmer-Amplifier-For-Rgb-5050-3528-Led-Light-Strip/192221834182?Sspagename=Strk%3Amebidx%3Ait&_Trksid=P2060353.M2749.L2649 These Are The Controllers I Use. Inexpensive And You Dont Have A Stupid Remote To Lose. The Cutout In The Sign Base Should Expose The Buttons On The Controller. I Use Hotglue To Secure This Inside The Base. Https://Solarbotics.Com/Product/Swt15/ Here Is A 2.1Mm Barrel Jack Plug With Integrated Rocker Switch I Found. It Goes Along Way For Making The Base Look Legit. Should Just Press Right Into The Base. Solder The Controller Leads Directly To The Paralell Terminals. Https://Www.Amazon.Com/Gp/Product/B072Krcjld/Ref=Oh_Aui_Detailpage_O02_S00?Ie=Utf8&Psc=1 These Connectors Are Not Essential, But They Make Life Alot Easier. I Cut Them In Half And Solder A Tiny Peice Of 22Ga Solid Wire On Each End. The 22Ga Solid Wire Plugs In Nicely To The Controller. I Use Hotglue To Secure The Wires Once The Controller Is Installed. Https://Www.Amazon.Com/Gp/Product/B00Gdxw3Oe/Ref=Oh_Aui_Detailpage_O00_S00?Ie=Utf8&Psc=1 These Self Threading Screws Go Through Both Halfs Of The Sign Base And The Acrlyc Sheet, Locking Everything In Place.
Statistics
Likes
73
Downloads
0