Gear and Mount for Slip Ring
Description
A Gear Designed To Work With [This Slip Ring](Https://Smile.Amazon.Com/Logisaf-300Rpm-Circuits-Capsule-Equipment/Dp/B01K48S6I0), Along With A Mount And Gear To Use With A 28Byj-48 Stepper Motor Such As [This One](Https://Smile.Amazon.Com/Toogoo-28Byj-48-28Byj48-4-Phase-Stepper/Dp/B00H8Kvdhe) The Slipring Gear Is A 1Mm Pitch, 54-Tooth Gear. The Grommets And Washers Allow For Use Of M3 Screws Without Nuts. The Gear For The Stepper Motor Is A 1Mm Pitch, 15-Tooth Gear. Depending On Print Accuracy, You May Require A M3 Screw To Keep It In Place. Mine Fit Snugly Over The Stepper Motor'S Output Shaft With A Small Amount Of Force. The Bracket Also Takes Two M3 Screws To Mount To The Stepper Motor. The Holes For The Slip Ring Don'T Line Up Perfectly, But You Can *Convince* The Grommets To Go Through With Only A Little Effort. I Didn'T Think About The Difficulty Of Holding The Grommets Still While Inserting The Screw, So They'Ll Have To Be Gripped With A Pair Of Pliers Or Something Similar Until I Update Them.
Statistics
Likes
26
Downloads
0