Prusa i3 MK2 - Linear Advance Calibration
Description
Two Testfiles That Allow You To Callibrate Linear Advance For Your Prusa I3 Mk2 3D-Printer. For Using Linear Advance You Will Need The So Calles "K-Factor", Deppending On Your Material The Needed Factor Will Be Between 0 And 100. For Pla Good Values Are Between 35 And 50. The Test Files Will Creates A Few Lines In Ascending Order. Both Files Start With A K Value Of 0 And Then A Step Size Of 5 Or 10 (Depending On The Used File). The Whole Test Only Works With The The Most Recent Firmware, Pla And Is Only Tested For I3 Mk2(S) 3D-Printers. For Me A K-Value Of 40 Seems To Be The Best For Pla. A More Detailed Instruction In Linear Advance And The Most Recent Firmware-Update For The Prusa I3 Is Available At Our Website (German Only): Https://3Druck.Com/Diy/Praxisbericht-Firmware-Update-Und-Linear-Advance-Beim-Prusa-I3-Mk2S-4765396/ For Further Testing There Is Also A Simple 20Mm Cube Included. A Pictures Showes The Difference Between The Cube With Linear Advance (Green, K=40) And Without Linear Advance (Red, K=0).
Statistics
Likes
18
Downloads
0