Micro 2.3" quad frame for Emax babyhawk power pack
Description
I Wanted To Try A 3D Printed Frame After Smashing Up The Original Babyhawk Frame And Various Small, Cheap Carbon Frames. I Was After A Unique Frame Design That Would Resemble Some Larger Freestyle Quad Designs Using A Lower Set Top Plate To Bring The Centre Of Gravity Down. This Design Worked Well Especially For The Emax Power Pack Components With An Upgraded Micro Camera And Vtx. I'Ll Also Attach Another Frame Design With A Higher Top Plate To Suit A 20X20X23Mm Stack If You Would Like A Higher Performing Micro Quad. The Tpu Camera Mount Was Designed By Https://Www.Thingiverse.Com/Thing:2470419 The Emax Femto F3 Flight Controller Holder Was Remixed From Https://Www.Thingiverse.Com/Thing:2041827 The Board Holder Was Remixed To Remove The 20X20 Mounting Holes And To Add A Gap To Run Beeper Wires Out From Under The Board.
Statistics
Likes
38
Downloads
0