Peg board shelf bracket spacer. Got droopy shelves?
Description
Note: This Was Designed In Autocad With Units Set To Inches. Please Remember That You Need To Give It A Scale Of 25.4 If You Want It To Print To The Correct Size. Sorry About That. I Will Likely Do Everything In Metric From Now On. I'M A Silly American. ;) The Pegboard I Have Is Somewhat Thin And It Causes My Shelves To Droop A Bit. Well That And Overloading The Shelves With Junk. I Was Tired Of Things Slowly Falling Off The Shelves And Fixed It With This Little Spacer. If You Can Lift Up The Shelf A Tiny Bit, You Won'T Even Need To Remove The Shelf To Install It. In Fact The Weight Of The Shelf Helps Greatly To Get These To Snap Round The Back Of The Bracket. Should Work With Wire Brackets With A Diameter Between .15" Â .215" Or Roughly 4 Â 5Mm. If You Have A Bracket With A Smaller Or Thicker Diameter You Should Be Able To Easily Scale It Up At Print Time.
Statistics
Likes
55
Downloads
0