christmas tree lamp
Description
This Is A Print And Then Assemble Project I Both Printed And Built In A Day So It Is A Nice Quick One To Do. I Printed The Front And Back Plates In Fillamentum Gold Happens, The Power Brick Was Printed In Vertigo Galaxy By Fillamentum And Then I Printed The Diffuser Or The Clear Triangle As It Is Named In The Stls In A Sample Of Clear Filament I Had From Colorfabb I Printed All Of These Models On The Cr-10 Using 0.2Mm Layer Heights Once All Of The Parts Are Printed I Glued The Clear Triangle To The Back Of The Fancy Tree Or Front Plate This Will Act To Diffuse The Leds So As Not To Have Bright Spots In Your Swirls. I Then Threaded The Leds Through The Hole In The Top Of The Power Brick Before Hot Gluing Them Evenly To The Back Plate Note I Used Micro Leds On Enamel Coated Motor Wire With A Colour Change Capability Then I Fixed The Front Plate To The Back Plate Using A Little Glue In The Hole Then Insert The Pegs And Last But Not Least I Glued The Completed Tree/Triangle Structure To The Top Of The Base Making Sure It Was Centralized Another Little Thing I Did Was Added Some Self Adhesive Velcro To The Inside Of The Power Brick Where The Batteries Will Be Housed And The Back Of The Battery Pack Makes It Nice And Neat And Easier To Change The Batteries I Hope U Enjoy Making This As Much As I Did
Statistics
Likes
13
Downloads
0