Longboard bumper (Airflow Skateboards - Around the World)

Description

# About I Designed These Bumpers To Prevent Further Nose-/Tail-Damage On My Longboard. They Are Ment To Fit Airflow Skateboards' "Around The World" Deck. As Mentioned, The Nose And Tail On My Board Have Already Suffered From A Little Wear, So If You Want To Print Them Yourself, **Paper-Print The Included Pdf First (At 100% - The Distance Between The Two Outer Screwholes Should Be 132Mm Center To Center)** To Check If The Grey Part Matches The Shape Of Your Board. # Installation The "Interlocking Part" Of Both Halves Has A Fair Amount Of Play. That Is Intentional And Meant To (Hopefully) Compensate (A Little) For Not Perfectly Straight Screwholes. Wait … Screwholes You Said?! Yes, To Install These Bumpers Onto Your Board, **You Need To Drill Six 3Mm Holes Through The Deck**. If This Is Not Your Kind Of Thing, Then These Are Not The Droids You Are Looking For. Sorry. First, Print One Half To Verify Again That It Will Acutally Fit The Shape Of Your Board. When You Are Sure It Does, Print The Other Half, Wrap Both Of Them Around One End Of The Board, Center It As Good As You Can And Drill The Middle Hole. Fit One M3X16 Screw Through The Whole Assembly (Six Screws With Six Matching Nuts Are Needed), Adjust The Position If Necessary And Drill The Remaining Ones. Repeat For The Other End, Done.

Statistics

Category

Tags