Catan extra piece holder with case

Description

I Loved This Holder, But I Wanted Something I Could Put My Extra Pieces In For Storage. I Added A Small Lip To The Bottom Of The Holder, Then A Box That Would Go Around It. To Be Glued On Top Is A "Tablet" Piece, It'S Just A Lid, But Since It Has A Design I Separated It So That It Would Print Properly Without Needing A Bunch Of Supports Or Printing Over The Air (If It'S Upside Down). Just Needs To Be Glued In Place. This Is The "Wide Road" Version Of The Holder, Which Fits The Roads As Printed When I Printed Them. I'Ve Printed A Few Test Pieces For This, But Had A Layer Shift Issue. I'M Printing A New Set Now And Hopefully Will Get Some Pictures Up Tomorrow (After I Print All 3 Parts). It'S Designed For A Monoprice Maker Select V2, With A 200X200Mm Bed. You Can Only Print 2 "Parts" At A Time, So The Tablet Has To Be Printed Separately, Which Is Fine Because I Want To Try Using Cura'S Ironing Feature On It, And I Wanted The Option To Not Have It On The Rest. This Is My First Published Thing, So I Apologize If I Made Any Mistakes. Update 12/12/2017: I Wanted A Good Way To Hold The Pieces Together That Went With The Magnet Theme, So I Edited The Models To Include A 3Mmx1Mm Depression For A Disk Magnet (It'S Actually Slightly Larger To Accommodate For My Printer'S Tendency To Print Things Smaller Than It Should). I Don'T Really Like How It Works On The Box. I Wanted A Little Tolerance For Fit, So The Box Is 1Mm Thinner Than The Lip On The Holder. That Makes The Magnet Offset, And Makes It So That It Won'T Really Print The Inner Gap. It'S An Aesthetics Thing, Shouldn'T Affect Functionality Once You Glue The Magnet In Place, But I May Edit It And Make It Look Better, Just Wanted To Put This Up For Anyone Wanting To Print It Update 2 For 12/12/2017: Did Some Thinking And Redesigned With A Slightly Larger Lip And Slightly Wider Walls To Accommodate For The Magnet. Also Designed That Pin That Goes Into It; The Pin Existed In The Thin Road Variant, But Not The Wide Road That I'Ve Remixed, But It Was Just Slightly Too Big. I Scaled It Down A Bit. When My Magnets Come In, I'Ll Take Some Photos Of Them Installed (Assuming They Fit Properly Of Course)

Statistics

Category

Tags