Tie Bar For Traxxas Stampede
Description
This Is A Tie Bar For The Traxxas Stampede Front End. I Know You Can Buy A Fiberglass Or Aluminum One, But I Decided To Design One In Tinkercad. I Have Not Tried Out On The Rc Vehicle Yet. Pla Printed At 100% Infill For Strength. Takes About 10 Minutes To Print On My Anet A8. This Is A Small Print So Make Sure Your Nozzle Height Is Set Right. If The Nozzle Is A Bit Too High, The Ends Will Curl Up Slightly And Will Make In Thinner Where The Mount Holes Are. I Added The Raised Letter Stampede Logo To Make It Unique. Final Note: I Would Say That This Is Mainly For Looks And If You Need A Really Strong Tie Bar, You Should Go With A Purchased Fiberglass Or Aluminum One.
Statistics
Likes
16
Downloads
0