DJI INSPIRE 2 TOP MOUNT HANDLE FOR GROUND FILMING
Description
Update: I Added A New Stiffer Front Top Plate. If You Are Going To Print In A More Flexible Material Like Petg, Abs Or Alike I Would Consider Using This Version. Original Is Completely Usable In These Materials But I Wanted It To Be A Little Stiffer. This Handle Is Designed To Be Used With The Dji Inspire 2, Allowing You To Use The Drone As A Ground Camera. This Will Allow You To Carry The Drone In An Under Slung Fashion Used By Many When Filming. Everything Fits Well And Attaches To The Inspire 2 In Areas That Will Not Risk Damage To Sensitive Equipment On Board. Use Your Slicer Software To Mirror The Front And Rear Lowers As Only One Side File Is Provided For Each. I Found This To Be Easier Than Mirroring In The Cad Software As Then I Did Not Have Control Over Position On The Print Bed. Additional Hardware Needed. 6-1/4 Inch 1/4-20 Threaded Rod (8) M3 X 20Mm Bolts (8) M3 Nuts (2) 1/4 Inch Flat Washer Or Can Use Lock Was In Addition To Flat Washers (2) 1/4-20 Wing Nuts. (1) Rubber O-Ring Or Heavy Duty Rubber Band (8) 3Mm Flat Washers Single Piece Rear Section Can Be Printed In Place Of The 3 Individual Pieces. This Requires A Larger Print Bed. Assembly And Installation Video, Be Sure To Watch The Video To Understand The Best Way To Mount To The Inspire. I Updated The Files For The Front Lowers So The Nuts Can Be Counter Sunk And Glued In Place So It Is Much Easier To Assemble. Https://Www.Youtube.Com/Watch?V=J3Icrwlj_Uq&T=40S
Statistics
Likes
19
Downloads
0