Rick and Morty Portal Gun
Description
My Daughter Wanted A Portal Gun For Dragon Con But You Couldn'T Buy Them Yet. So I Went Ahead And Designed One For Both Of Us. I Incorporated Leds Into The Gun And Some Minor Electronics To Make It Cool Looking. The Counsel Of Ricks Badge Was Not My Design. I Am Posting The Answer To Two Questions Here As Well And Adding A Picture To Help Explain. I Used Magnets In The Tubes That I Designed Into The Bottom Box Portion And Thin Metal Squares Were Melted Into The Lid To Create A Secure "Closing" Of The Gun. It Works Very Well. Also Shown In This New Picture Is The Wiring As It Is And The Battery Compartment I 3D Printed. (Props Go To The Designer Of The Battery Holder, Nice Job.) You Have To Add Metal Contacts To It, But It Works Very Well. I Used Gaffer'S Tape To Keep Light From The Leds From Going Everywhere As Well As Some Metal Tape. They Are Very Bright Leds. I Used A Bubble Magic Wand For My Green Fusion Container Instead Of Printing It. Bought A Goo Spike Ball, Cut It In Half And Wrapped It Around Some Leds Before Putting It In The Green Container. As With All My Items, It Is Not Required, But A Tip Through Paypal Is Always Appreciated For My Work. Thanks And Enjoy!
Statistics
Likes
16
Downloads
0