Fan mount FT-5 (Stock)

Description

This Is A Fan Mount For The Ft-5 Using A Stock Extruder And Fitting On The Stock Mount With A Little Modification. Recommended To Print In Two Pieces And Adhere Together. Can Be Printed Entirely At Once. Uses On 40 Mm Fan, Same As On The Extruder. To Install: *Remove Screws Holding Extruder Motor To Carriage *Drill From Motor Side Halfway Through Carriage Mount So Screws Holding Fan Mount Are Flush *Install Mount Using M3 10Mm Screws And Flat Square Bolt As Found In Kit *Reinstall Extruder Motor Adjust As Needed

Statistics

Category

Tags