Block heater plug cover
Description
Ran Into An Issue Where My Dad'S Diesel Wouldn'T Start One Very Cold Morning. So I Went To Plug In The Block Heater And I Noticed Right Away It Wasn'T Going To Work Because The Terminals On The Truck Side Were Terribly Corroded. So After Cleaning Those Off, I Made This To Cover The Plug In Hopes That It Wouldn'T Corrode Again Any Time Soon. The Strap Is Made From Ninjaflex, So I Could Get It Around The Plug. The Strap Has A Small Loop And A Big Loop. The Small Loop Goes Onto The 3D Printed Cover. The Big Loop Is For Going Around The Plug End On The Truck Side.
Statistics
Likes
4
Downloads
0