Filament Spool Holder
Description
Filament Spool Holder ==================== A Simple Filament Spool Holder Which Can Be Printed In One Part On Most 3D Printers. Note --------------------- The Original Version Could Be Printet With 10 Infill, I Am Unsure If This Remix Will Work With 10 Infill. The New Remix Is Made With Sketchup And Only The Size (Width / Height ) Is The Same. New In This Remix: --------------------- * Making The Base Wider, Making It More Stable. * Making The Back Wider, Making It More Stable. * Making A Hole / Gap In The Middle On The Holder, Making It Have A Less Volume (Lower Printing Cost). (Vol:0.18 Cm3 Without The Gap - Vol:0.17 Cm3 With Gap) * Made It "Water / Air Tight". Making It Useable For Print Houses To Calculate Cost Without Having To Fix Holes / Gaps Etc In The Stl. * Made The Stop Part (To Avoid The Spool From Falling Of) A Full Polygon Instead Of Half Polygon (Simply Didnt Like The Look) * Removing A Ton Of Lines That Had No Purpose ( Just To Make It More Clean Looking In Sketchup)
Statistics
Likes
0
Downloads
0