Curvy Guitar Mount (Remix)

Description

This Was Modified From [Roytorehofstad'S Creation](Https://Www.Thingiverse.Com/Thing:481198). I Moved The Top Screw Holes Toward The Center, Because Most Wall Studs In My Area Are Only 1.5 Inches Wide, And Finding The Exact Edges Of A Stud Is Not Easy. I Also Extended The Tips Of The Arms Slightly Vertical, So As To Deter The Guitar From Falling If Twisted On The Mount. I Printed This On A Monoprice Mini Delta Using Hatchbox Wood Pla, 0.1Mm Layers At 200°C. The Model Was Printed With The Wall-Face Against The Printer Bed (Arms Pointing Up, So As To Reduce The Need For Supports). I Did Use Supports, However I'M Not Sure If They Were Really Needed At All. I Chose 50% Infill, Which Felt Very Difficult To Bend Or Break. Print Time Was Around 8 Hours. There Were Quite A Few Extra Strings To Remove After The Print (I Still Need To Tweek The Settings For Wood).

Statistics

Category

Tags