Mushroom Grinder Question Mark Box
Description
Printed @ 100% Infill And With 7 To 10 Percent Supports. Used Small Hinge Design By Robhumm Https://Www.Thingiverse.Com/Thing:21444 And That Is Printed At Same Settings @ 100 Percent Scale. Same Scale As The Box Basically. The Orange One Is Printed @ 100% Scale And The Grinder Fits Pretty Good But Without Bottom Bracket. The Glow In The Dark One(White) Was Printed @ 102% Scale, And The Bracket Fits The Grinder Pretty Well, The Grinder Doesnt Fit The 100% Scale Box. Please Excuse The Peices In The Middle Of The Bracket, I Am Trying To Design A Rising Platform So The Mushroom Rises When You Open The Box, But It Is Taking Too Much Time To Perfect, So I Figured I Would Release Part Of It So The Grinder Can Sit In It. I Will Be Updating Eventually With A Newer Design But This One Works Well. Also The Hinges Are Glued To The Box Starting With The Lid (Thats What I Did At Least). The Part Of The Hinge With One Loop As Opposed To Two Is Glued To The Lid. It Is The Smaller Side When Looking From The Side Of The Hinge. Should Be Glued Right On Each Corner Of The Lid And Should Be Flush With The Top And Side Of The Lid. Hope You Guys Enjoy! My First Design For Thingiverse....No Design Experience, Just Going Off Of Will And Instincts :)
Statistics
Likes
67
Downloads
0