ImmersionRC Vortex 285 Angled Wall Mount
Description
This Thing Is Now On Myminifactory And Shall Be Updated There Only Https://Www.Myminifactory.Com/Object/3D-Print-100254 --------------------------------------------------------------------------------------------------------------------- --------------------------------------------------------------------------------------------------------------------- Been Wanting To Hang Mine And My Wife'S Vortex 285'S On The Wall For A While Now And Finally Got Around To Designing A Mount For It Seeing As I Couldn'T Find Any. This One Angles The Quad 30 Degrees Off The Wall To Make Your Quad Pop A Little Rather Than Just Hang. Included Are 2 Versions, One With My Logo And One Without (I Know How Irritating It Is For Models To Have Branding On So I Left A Blank Copy If It Bothers You As Much As It Does Me :) I'Ve Angled The Model In The Stl File So That As There Are 2 Points Of Contact With The Build Plate. Adding Supports Will Further Stability While Printing But Isn'T Necessary If You'Ve Tuned Yours In. Supports For Me Were Done At 70% To Avoid Excess Material Waste. Mounting Your Print To The Wall Is Simple. I Designed It So There Is A Nice Flat Spot On The Back For Double Sided Tape. Simply Place It Where You Want Then Drill Into The Wall Through The Pre-Made Hole In The Mount And Screw It Down.
Statistics
Likes
4
Downloads
0