Cable holders & molds
Description
With Too Many Gadgets Come Too Many Cables, So To Keep Them In Place I'Ve Designed Molds To Produce Simple Cable Tidies For A Number Of Different Diameter Wires. Once The Mold Is Printed And Cleaned, Dust It With Talcum Powder Lightly On The Inside Making Sure All Areas Are Covered, Then Fill The Mold Carefully With Household/Builders Silicone Taking Care Not To Trap Any Air, Fill To The Top And Smooth Off. Allow To Cure For At Least A Few Days Then Remove Carefully From Mold. I Designed It For Use With Double Sided Sticky Tabs Of 20Mm Dia Or Square, So Once Its Out Of The Mold Either Use Double Sided Tape/Tabs Or Hook & Eye Spots And Place Where Needed, The Cables Should Push In And Out Without Too Much Resistance But Be Held Neatly. There Are Molds For Cables Of Upto 4Mm, 5Mm, 6Mm, 7Mm, And 10Mm. I Made Them All The Same Height So That Different Sizes Would Match If Used In A Row. 4Mm Should Take The Majority Of Gadget Charging Cables, 7Mm Sat/Tv And With The Rest I Hope To Have Covered Most Needs. This Thing Was Made With Tinkercad. Edit It Online Https://Www.Tinkercad.Com/Things/B7Dgjejynzw
Statistics
Likes
5
Downloads
0