OP1 Hard Case
Description
My Original Cardfoam(?) Case For My Op-1 Was Getting A Bit Tatty, So I Set About Creating A Hard Case From 3D Printed Parts. This Is Unashamedly Modelled On The Beautiful - But No Longer Available, Natch - Hardwood Case From [Pendeo](Http://Www.Synthtopia.Com/Content/2014/09/08/Pendeo-Intros-Hardwood-Op-1-Case-Monolith-Adapter/). Designed To Fit The 20X20Cm Print Area Of Yer Average Printer, The Case Consists Of 6 Pieces - So Some Assembly Is Required... In Addition, You Will Need 12 X 5Mm Dia. 3Mm Thick Neodymium Magnets. Of Course, These Are Available Online - I Use [First4Magnets](Https://Www.First4Magnets.Com) In The Uk.
Statistics
Likes
28
Downloads
0