LM8UU mount replacement for Monoprice MakerSelect v2.1
Description
Never Understand Why There'S Only 3 Lm8Uu Bearing, Instead Of 4, On The Wanhao/Mp Makerselect 2.1 Underneath The Y Axis Plate. Nevertheless, I Want 4 Bearings Because I Can See The 2 Corners Bend On The Y Axis Plate When I Adjust Those Spring (The 2 Corners Where Only 1 Bearing On The Y Axis Rod) Modify Xnaron'S Holder For Wanhao/Mp Makerselect 2.1 Y Plate. Working Great So Far For Couple Overnight Print. Now All 4 Corner Is Straight And Leveled, Don'T Need To Spend Extra Money On A New Y Plate And Found Bed Leveling Easier. I Re-Use The Existing M4 Screws From The Mount That Came With The Printer And It Just Fit, But If You Have Slightly (2~3Mm) Longer M4 Screws That'S Even Better. Just In Case You Wondered, I Ran Out Of M4 Nuts, That'S Why I Only Put 3 Screws Per Mount In My Photos. __Note Please Pay Attention To The Y Axis Plate I Have, If Yours Different Then The Screw Holes May Not Line Up.__
Statistics
Likes
31
Downloads
0