XBox One S Contoller Stand
Description
This Is A Xbox One S Contoller Stand I Designed For My Computer Sidewall Which Allows To Hang The Wire. I Advise You To Print It In Two Parts, Then Gluing Them With Epoxy For More Strength. You Can Use Toothpick For A Better Alignment (After Having Drilled A Hole At The Good Diameter). I Gor Some Warping During Th Print, So I Made A 7Mm Spacer To Fit Perfectly. It Doesn'T Affect The Ability To Support The Controller (It'S Even Better...). I Put The Two Parts *_Ext3P5 With The Half Spacer Already Added On Each Side. As Usual, The Fusion 360 File Is Available.
Statistics
Likes
21
Downloads
0