ReDuplicator i3 MK3x - Titan Aero Mount
Description
This Titan Aero Mount Was Designed To Be Compact As Possible In The Available Space. This Is Done By Keeping The Hotend Closer To The X Axis Rods Than Other Mounts, Minimizing The Z Height And Width Profile While Keeping It As Strong And Light As Possible. It Was Designed For The Reduplicator Mk2Sx Which Started Life As A Wanhao Duplicator I3. This Uses The Same X Carriage Rear Bearing Plate As The Original Mk10 Re-Duplicator Carriage. It Can Be Found On The Original Project [Here.](Https://Www.Thingiverse.Com/Thing:2686588/#Files) The New Shroud Is Based On The Prusa Mk3 One. It Results In Much Better Overhang Performance. 60 Degree Overhangs Are Flawless With Some Sagging [@70 Degrees.](Https://Raw.Githubusercontent.Com/Omnomnomagon/Reduplicator-Mk2Sx/Master/Pics/9%20Titan/Overhang.Jpg). It Is Almost Comparable To The [Dii Cooler Via Testing.](Https://Www.Reddit.Com/R/3Dprinting/Comments/7Kexdv/A_Nearly_Comprehensive_Study_Of_Cooling_Fans_And/) Make Sure Your Re-Duplicator Idler Part Is The New V2 Design It Includes Additional Mounting Points For The X Endstop. The X-Axis Endstop Is Mounted On The Bottom Of The X-Axis Idler Part. The Endstop Will Need To Be Relocated To The Middle Or Furthest Holes Depending On The Positioning Of Your Heatbed. However If You'Ve Already Printed The Original Idler V1, New Holes Can Be Drilled In At 5Mm Intervals With A 1.5Mm Drill Bit. The New Required Printed Parts When Upgrading From The Mk10 Extruder Are The: - Front Bearing Plate - Titan Aero Mk3 Part Cooling Fan Mount - Titan Aero Mk3 Part Cooling Fan Shroud - Bltouch Mount (Optional).  Probe Offset Values For Marlin Configuration \#Define X_Probe_Offset_From_Extruder -16 \#Define Y_Probe_Offset_From_Extruder -42
Statistics
Likes
186
Downloads
0