Perma-proto mount with threaded inserts
Description
I Modified Davegun'S Original Mount To Enable The Use Of Threaded Inserts. This Allowed Me To Glue The Mount Flush To My Acrylic Panel Without Worrying About Fasteners On The Backside. I Used 6-32 Heat Set Threaded Inserts From Mcmaster-Carr (Pn 93365A132) Because That'S The Smallest Size I Had On Hand, But The Holes In The Perma-Proto Board Are Actually Slightly Smaller Than A #6 Screw So I Drilled Them Out To 1/8". The Brass Inserts Could Short A Couple Of Columns, So You Might Want To Use Kapton Tape Or A Nylon Washer. I Didn'T Have Any Problem With Shorting.
Statistics
Likes
6
Downloads
0