HP DPS-600PB Power Supply Cover (XT60 Connection)

Description

Designed Power Connection Bracket For The Dps 600-Pb Power Supply Unit That Has A Switch Attached To It. The Switch Can Be Used To Trigger The 12V Power Signal (The Green Light At The Back Of The Psu Indicates That Power Is Switched On). I Used Some (I Guess) Non-Original Xt60 Connectors That I Bought From China. They Do Not Have A Fold, So My Solution Is That The Switch Is Pressed Quite Tightly Into The Hole And Afterwards I Added Some Glue To Make It Stick. In Case Your Xt60 Connector Does Not Fit Let Me Know. I Will Then Modify The Stl Files For You ;-) The Back Relief At The Hole For The Switch Is Used To Prevent The Switch From Turning. Afters Printing Just Stick The Screw Nuts Into The Holes. There Is No Need To Heat Up The Screw Nuts As In Other Models Here On Thingiverse. After Assembly You Can Screw The Bracket Into The Psu. I Drilled Out The Original Threads Of The Psu With A 3 Mm Drill. Therefore You Can Tighten The Bracket Against The Psu. Make Sure Your Srews Ar Short Enough To Not Damage The Psu.

Statistics

Category

Tags