Asus MB169b+ portable USB LCD stand
Description
Stand Which Will Hold Your Portable Usb Properly On Portrait And Landscape Modes. The Case Which Can Be Turned Into A Stand Is Too Finicky To Have It For Some Proper Setup. The Legs Are Reaching Good Bit To Back And Bit In Forward So It Should Make Stable Stand No Matter What. The Stand Itself Is 3Cm Wide And Is Meant To Be Printed Multiple Times, Even When In Landscape Mode You Might Get Away Just With 1, I Still Prefer To Use 3 Of Them To Make It Really Riggit, For Portrait Mode Even 3-4 Of Them. Can Be Printed On Lowest Settings 0.3Mm Height Without Any Support, 3 Perimeters, 3 Top And 3 Bottom Layers, And Even 15% Infill Could Be Enough, I Think From The Top/Bottom And Perimeters Is The Most Of The Strength. The Fit Is Tight, So You Might Want To Observe You Bezel (I Found Out That My Model Doesn'T Have Perfectly Flat Bezel And Actualy There Are Gemotry Changes Maybe In 0.5Mm Scale, But There Are Changes, So On Some Places It Might Be Too Tight, Still It Works On All Places I Could Imagine). There Is Parametric Source File Where You Should Be Able To Tweak And Change The Dimensions Easily. There Are Few Tilt Wariants Which Have The Top Face Slightly Tilted By Different Degrees.
Statistics
Likes
3
Downloads
0