Ikea UTÅKER Stackable Bed Raiser
Description
Note: I Make No Claim Or Warranty About Safety Or Stability Of These Under The Bearing Of Any Load. You Do So At Your Own Risk. I Had Bought This Bed From Ikea: Http://Www.Ikea.Com/Us/En/Catalog/Products/30360487/ Turns Out The Mattresses They Displayed With It Were About An Inch Too Tall For The Beds To Properly Stack, So I Made These Risers To Fit Between The Beds To Accommodate The Added Mattress Heights. They Have A Side With A Hole For The Top Beds Peg To Fit Into, And A Peg On The Opposite Side To Fit Into The Bottom Bed'S Hole For Stability. I Also Gave Them The Same Curvature As The Bed Legs To Blend In Ascetically. They Give A 1.5" Rise So You Can Comfortably Accommodate A 6" Mattress Instead Of A 5" Mattress When Stacked. I Printed Them With 65% Infill Because I Was Paranoid About The Sturdiness And Support In Case Someone Accidentally Sat Or Jumped Onto The Stacked Beds While I Had The Risers In There. Feel Free To Send Me A Tip If You Like What I'Ve Done! <A Href="Https://Www.Thingiverse.Com/Frank_The_Tank/About">Click Here!</A>
Statistics
Likes
1
Downloads
0