Delta board mount for extruded frames
Description
Print On Its Side Was The Best For Me But Feel Free To Experiment. 100% Infill Is A Must Had One Break That Was 50%. I Used Support For The Slot You May Not Have To, I Also Used 55C On The Hotbed. I Needed A Mount For My Mks Sbase V1.3 Board And Did Not Like What Was Available So I Tried To Make Something All Snazzy And Cool Looking But, It Would Not Stick At All No Matter What And Did. It Did Not Allow For Adjustment. So Back To The Drawing Board And I Came Up With This, It Is Simple And Has A Slot For Adjustment. I Use A 4Mm Screw On The Short Leg And A 3Mm Screw On The Long Leg And It Holds Things Just Fine. I Also Use It To Mount My Mosfet Board Under The Hot Plate (Not Shown) Also.
Statistics
Likes
12
Downloads
0