wire holder - clamp
Description
Hi! Wife Asked Me For A Clip/Clamp/Holder For The Cord That Charges Her Phone. Made This Small Clamp That Would Fit Multiple Sizes Of Cord, From Big Fat Earphone Wires To Little Tiny Headphones Cords.. Basically, You Put Double Sided Tape On The Side Of The Clamp, And Stick It Somewhere. To Hold The Cord, You Just Slide It In And Pull It In The Notches Until The Wire Is Snug. The Usb Cord It Was Made For Fit Perfectly In The Middle Spot.. **Note That It'S Very Hard To Get Certain Surfaces To Stick So Make Certain You Wither Sand The Printed Part For Extra Grab, Or Use Really Good Tape.... It Can Very Easily Be Made Bigger Or Smaller, Although You Only Need To Enlage Or Shrink The X And Y, The Z Is Fine At The Current Size (Unless You Have Heavy, Big Cables I Guess. Please Like It If You Do, And Comments Are Welcomed. Seb Ps: I Made Mine Out Of Abs Because I Was Afraid Pla Might Be Too Brittle To Handle The Strain When Pushing The Wires In. It Might Work Especially If It'S A Wire That Does Not Get Removed And Put Back In Often. Let Me Know If You Try. Pps:I Put In The .123D File, If You Want To Play With It. If You Modify And Post It, Don'T Forget To Credit Me.
Statistics
Likes
20
Downloads
0