Ruler Sliding Guide Clamps
Description
These Are Designed To Aid In Making Measurements With Various Rulers, In Order To Clamp You Need To Add Some Hardware. Inside The Slide Is A Spot To Insert An M3 Nut, I Find It Easiest To Screw The Nut Into A Bolt Then Press It In. To Tighten You Need To Provide Either A M3 Bolt With A Handle Or An M3 Thumbscrew (At Least 6Mm Long Bu Preferrable 8Mm). Note: Over Tightening Will Cause Movement And Scare The Ruler, Only Use A Hand Tighten Screw Not A Driven Screw! 1/29/2018: Planning On Adding Some Sae Versions Of These Along With Some Tweaks To The Existing Ones In The Weeks To Come. 2/3/2018: Added Sae Versions With 4-40 And 6-32 Nut Inserts
Statistics
Likes
186
Downloads
0