Greg's Wade Bowden extruder Creality Ender 2 / CR 10
Description
Video: Https://Www.Youtube.Com/Watch?V=Tfdmygnhwy4 This Is Greg'S Wade Extruder Adapted For The Ender 2, Probably Also Fits The Cr 10 (Not Tested). With The Extruder The Ender Prints Much Better And You Can Relieve The Stepper Driver Without Step Losses. My Nema 17 Engine Is Only Lukewarm, Previously Very Hot. The Esteps Must Be Adjusted, With The Original Firmware Can Not Save, Must Be Entered At Each Reboot. That'S Why I Flashed My Ender On Marlin. That Is Relatively Easy, Instructions Are Available Online. Have Fun With It (Original Description: Adapted For E3D Hobb Goblin 8Mm Hobbed Shaft Adapted For Pc4-M5 Bowden Connector Filament Path Is Extended To Provide Contact With Hobb Goblin 8Mm Hobbed Shaft And 608Zz Skate Bearing. This Extended Path Should Allow For Flexible Filaments Without The Potential For Kinking Material. Assembly Instructions / Bill Of Material : Http://Reprap.Org/Wiki/Wade'S_Geared_Extruder )
Statistics
Likes
52
Downloads
0